Entering Custom Data for Liquid-Rich Gas

Note that custom properties are not used in wellbore calculations.

To enter custom data for liquid-rich gas:

1. Click the Properties tab.

2. Click Gas in the Properties pane.

3. Click the Change Plot Options icon.

The Plot Options dialog box opens.

4. Select the properties you want to display (i.e., numerical or non-numerical) and click OK.

5. Click the PVT Correlation drop-down list and select Custom Table.

6. Enter data into the p column; then enter data into either the Z or B_g columns of the Custom Table. The other data will be calculated.

7. Click the Viscosity Correlation drop-down list and select Custom Table.

8. Enter data into the p and μ_g columns.

9. Click the Gas Type drop-down list and select Liquid-Rich Gas.

10. Click the Vaporized Oil Ratio Correlation drop-down list and select Custom Table: Liq. Drop-Out.

11. Enter the required data in the Gas Properties section.

12. Enter data into the p and V_L / V_sat columns.

13. Click the View Plot icon to verify that the custom-input data is reasonable.