Abbreviations

Type Treatments

Bul Bullet Perforations

Jet Jet Perforations

Selbul Selective Bullet Perforations

Seljet Selective Jet Perforations

Hydjet Abrasa-Jet Perforations

Permtr Permeator Perforation

Slotli Slotted Liner or Casing

Openh Open Hole Completion

Acidw Acid Wash - No Pressure

Acidsq Acid Squeeze - Press Used

Condsq Condensate Squeeze

Visq Visqueeze

Ch Sq Chemical Squeeze

A Sq Alcohol Squeeze

Ni Tr Nitrogen Treatment

St Inj Steam Injection

Frac Fractured

Hydrsq Hydromite Squeeze or Plug

Cempl Cement Plug

Cemsq Cement Squeeze

Cembrp Bridge Plug Capped W/Cement

RemCsg Remedial Casing

Type Perfs

S/F Shots Per Foot, Conv.

S/M Shots Per Metre, Metric

Type DST's

OH Open Hole Size

Csg Casing Size

Strd Straddle Test

Type Flows

GTS Gas to Surface

WTS Water to Surface

OTS Oil to Surface

TSTM Too Small to Measure

Type Times

VO Valve Open

SI Shut In

Type Pressure

HP Hydrostatic Pressure (psig-Imp, KPa- SI)

SIP Shut in Pressure (psig-Imp, KPa-SI)

FP Flowing Pressure (psig-Imp, KPa-SI)

Type Recoveries

Wtrcush Water Cushion

O Oil

Mud Mud

GCMud Gas Cut Mud

OCMud Oil Cut Mud

WtrCMud Water Cut Mud

Cond Condensate

Wtr Water, with a combination of the following:

GC Gas Cut

OC Oil Cut

Sul Sulphurous

FR Fresh

BR Brackish

S Salt

 e.g., SULSWTR - Sulphurous Salt Water

Type Analysis

SG Specific Gravity (gm/cc-Imp)

DEN Density (kg/m3-SI)

Kg/M3 Density (kg/m3-SI)

API American Petroleum Institute gravity (degrees)

Mg/L CL Chlorides (mg/l -Imp)

Kg/M3 CL Chlorides (kg/m3-SI)

CO2 CO2 (percent by volume-Imp dim. ratio-SI)

H2S H2S (percent by volume-Imp dim. ratio-SI)

GPM Liquids (gallons/thousand cubic feet-Imp)

LIQ Liquids (ml/m3-SI)

Type Additional Abbreviations on IPL Tests

BS&W Bottom sediment and water (m3-SI, bbls-Imp)

CH Choke (size) (mm-SI, inch-Imp)

FAS Flow after swabbing (Rate or Time or Both)

FBS Flow before swabbing (Rate or Time or Both)

FFL Final fluid level (m-SI, ft-Imp)

FL Fluid level (Single value or Range-Initial/Final)

FLS Fluid level after swabbing (m-SI, ft-Imp)

FP Flowing pressure (Kpa-SI, psi-Imp)

GRDF Gas rate decreasing from (m3-SI, mcf-Imp)

IFL Initial fluid level (m-SI, ft-Imp)

OLFR Original load fluid recovered (m3-SI, bbls-Imp)

OR Orifice (size) (mm-SI, inch-Imp)

SAL Salinity (ppm-parts per million)

SIP Shut in pressure (Kpa-SI, psi-Imp)

SW Swabs (number of)

VO Valve open (time-typically hours)