| With this feature... |
Do this... |
| Display pane |
Select the wavelet with which to work. Clear Show all wavelets if you're already working with the desired wavelet
to increase the work space in this dialog box. |
| Name |
Type a name with which the wavelet is identified in
the main synthetic display. |
| Type |
Select a predefined filter to apply to the wavelet selected
in the display pane. Controls to specify the cut and pass frequencies
appear below based on your selection. |
| Attribute |
Select the mathematical transformation used to explain
the data. |
| Amplitude |
Type the display amplitude of the trace data. |
| Reflection Coefficients |
Select the source curve and method to use when creating the AVO logs. Click Create AVO Log suite to create numerous types of logs to use
in AVO analysis. |
| Multiples |
Select whether to display simulated first order multiples
alongside primary reflections, or to just display multiples and not the
primary reflection. First order multiples are the first reflection of
a primary reflection. |
| Cutoff % Max RC |
Type the maximum percent for the reflection coefficient
below which multiples are not shown. GeoSyn calculates the maximum reflection
coefficient in the model, uses a percentage of that, and ignores all reflection
coefficients less than that. |
| AGC |
Type a value for the automatic gain control. |
| Noise
|
Select the Apply check box and then click Edit to display the Noise Parameters dialog box, where you apply noise type. |
| Wavelets |
Click Edit to display the Wavelet Properties dialog box, where you change wavelet and spectrum properties. |