Populating the Hybrid Model

Once the model is created, you need to populate all required parameters.

Note:    Some of the model parameters (i.e., initial pressure, fluid saturations, net pay etc.) are already specified in the Properties Editor.

To populate the hybrid model:

1. Copy parameters from the Properties Editor to the model by clicking the Defaults icon ( ) on the toolbar; then select Reservoir from the drop-down list.

2. Copy all available parameters from the previously made analysis by clicking the Defaults icon () again, and selecting the appropriate analysis. If you have any analytical gas horizontal multifrac model created for the same well, we recommend that you use it to populate the hybrid model's parameters.

Or, if you want to copy only one parameter from the analysis, click the View Defaults and Limits button to the right of the field. Select the appropriate values and then click the Accept button.

Note that parameters copied from the reservoir or another analysis are displayed in a gray font. This indicates that they match the default. You can type new values for any parameter, or change values for some parameters by moving elements of the schematic. Parameters, which do not match the default, will be shown in a black font.